Module
20 min.
Analysis and design
Module overview
Run calculations on a structural model and review the analysis, as well as perform design calculations for steel and reinforcement elements in the model.
This content takes approximately 20 minutes to complete. By the end, you should be able to:
- Run static analysis and review the results of the analysis.
- Perform steel design for selected elements.
- Calculate slab reinforcement for selected elements.
About the author
This content was created by Pawel Pulak, Designated Support Specialist at Autodesk.
Before you start
- Please make sure you have the Revit and Robot software loaded.
- If you have technical difficulties, please reach out to product support.
Module downloads
These downloadable resources will be used to complete units in this module: