Creating and revising walls
Draw straight walls. Use the direct distance entry technique. Draw walls with chain enabled. Apply flip controls for wall orientation.
Step-by-step guide
Draw walls with and without chain enabled, use the direct distance entry technique, and apply flip controls for wall reorientation.
- In the Options Bar, deselect Chain.
- In the Modify | Place Wall tab, Draw panel, select Line.
- Pick a point, pull it to the left, and press ENTER to place a wall.
- Pick a point above the wall to create another wall.
With chain disabled, each wall is created separately.
- In the Options Bar, select Chain.
- Draw two or more walls to see that they are now continuous.
- On the Ribbon, click Modify.
- In the View Control Bar, expand Detail Level and select Medium.
You can now see the layers of the wall.
- Select one of the existing walls and use the temporary dimensions to change the distance between the walls.
- Press ESC.
- Select one wall and click the Flip control to flip the external face.
- Hold down CTRL and select more than one wall.
Now, there are no flip controls.
- Press SPACEBAR to flip the direction of multiple selected walls.
- Zoom out and select all the walls.
- Right-click the selection and select Delete.