Module

20 min.

Defining loads and combinations

Module overview

Learn how to define loads on structural members and create load combinations that can be used in analysis programs. 

This content series takes approximately 20 minutes to complete. By the end, you should be able to: 

  • Define loads on structural members.
  • Create load combinations.

About the author

This content series was created by Pawel Pulak, who has over over 20 years of experience in the structural analysis software and supporting users of Autodesk Robot Structural Analysis and predecessors of this product. 

This content series is narrated by Martha Hollowell Orcutt.

Before you start

  • Please make sure you have the Revit software loaded.
  • If you have technical difficulties, please reach out to product support. 

Module downloads

These downloadable resources will be used to complete units in this module:

Module outline