Setting Up Revit and Adding Reinforcing
Adding rebar to a bridge design is most efficiently done in Revit. In this module, you learn how to reinforce bridge piers in Revit. Then, you configure your visibility graphics to clearly see the rebar that was placed.
‌
Module overview
Adding rebar to a bridge design is most efficiently done in Revit. In this module, you learn how to reinforce bridge piers in Revit. Then, you configure your visibility graphics to clearly see the rebar that was placed.
This module takes approximately 20 minutes to complete. By the end of the module, you should be able to:
- Set up the correct levels in Revit
- Add pier reinforcing
- Configure visibility graphics
Module pre-requisites
This module requires user-level knowledge of InfraWorks and is focused on best practices and its industry applications. If you don't have experiences with this product, we recommend you to take foundational training using one of the resources below:
- Built-in tutorials, available via in-product Help
- eLearning Partners
- Authorized Training Centers