Create Autodesk factory design assets
This content series covers the critical step of implementing Autodesk Factory Design solution - Factory Assets creation in Autodesk Inventor.
‌
Module overview
This content series covers the critical step of implementing Autodesk Factory Design solution – Factory Assets creation in Autodesk Inventor.
This content series takes approximately 20 minutes to complete. By the end, you will be able to:
- Set up and configure your own Factory Design implementation.
- Understand factory design workflows: Inventor, AutoCAD, and Vault.
- Start using Asset library.
About the author
The content series was prepared by Stephen Porath, the designated support specialist here at Autodesk.
Before you start
- Make sure you have AutoCAD and Factory Design Utilities installed.
- If you have technical difficulties, please reach out to product support.