Challenge exercise: Create a CAM setup and toolpaths for Lathe
Apply your knowledge and skills to create a CAM setup and toolpaths for Lathe.
This challenge exercise is part of the Introduction to CAD and CAM for Milling and Turning.
‌
Module overview
Build on your skills by completing this challenge. To complete this challenge, you'll need to:
- Use direct modeling to remove internal threads in one of the holes.
- Create a new Turning setup.
- Import a tool library and create any needed custom tools.
- Create Turning Face, Groove, and Chamfer operations.
- Create Turning Drill toolpaths for the bores and tapped holes.
- Create a Turning Thread toolpath.
Before you begin