• Revit

Create piping systems in Revit

Create piping systems and manage them using the system selector.


Tutorial resources

These downloadable resources will be used to complete this tutorial:


00:03

In Revit, you can create piping systems and then manage them using the System Selector.

00:10

To create a new piping system type for this example, in the Project Browser, scroll down and expand Piping Systems > Piping System.

00:21

Right-click Hydronic Supply and select Type Properties.

00:27

In the Type Properties dialog, click Duplicate.

00:31

In the Name dialog, enter “Heating Hot Water Supply”, and then click OK.

00:38

Next to Graphic Overrides, click Edit.

00:42

In the Line Graphics dialog, change the Color to Red.

00:47

Then, click OK to close each of the two dialogs.

00:52

Now, to create a piping system in your model, select a water source heat pump.

00:58

Then, in the contextual ribbon, in the Create Systems panel, click Piping.

01:05

In the Create Piping System dialog, for the System type, select Heating Hot Water Supply.

01:12

For the System name, enter “HWS-1”.

01:18

Enable Open in System Editor, and then click OK.

01:23

To add water source heat pumps to the system, in the Edit Piping Systems panel, click Add to System.

01:31

Select the additional equipment you want to add to the system.

01:37

Once you have selected all the necessary water source heat pumps, in the contextual ribbon, click Finish Editing System.

01:46

Then, all the water source heat pumps on your system appear, based on the graphic overrides assigned by the family system type.

01:55

Finally, select a water source heat pump in your piping system and switch to the Piping Systems contextual ribbon.

02:03

The System Selector then shows you all the systems that the selected water source heat pump belongs to,

02:10

and the Properties palette updates with all the system properties.

Video transcript

00:03

In Revit, you can create piping systems and then manage them using the System Selector.

00:10

To create a new piping system type for this example, in the Project Browser, scroll down and expand Piping Systems > Piping System.

00:21

Right-click Hydronic Supply and select Type Properties.

00:27

In the Type Properties dialog, click Duplicate.

00:31

In the Name dialog, enter “Heating Hot Water Supply”, and then click OK.

00:38

Next to Graphic Overrides, click Edit.

00:42

In the Line Graphics dialog, change the Color to Red.

00:47

Then, click OK to close each of the two dialogs.

00:52

Now, to create a piping system in your model, select a water source heat pump.

00:58

Then, in the contextual ribbon, in the Create Systems panel, click Piping.

01:05

In the Create Piping System dialog, for the System type, select Heating Hot Water Supply.

01:12

For the System name, enter “HWS-1”.

01:18

Enable Open in System Editor, and then click OK.

01:23

To add water source heat pumps to the system, in the Edit Piping Systems panel, click Add to System.

01:31

Select the additional equipment you want to add to the system.

01:37

Once you have selected all the necessary water source heat pumps, in the contextual ribbon, click Finish Editing System.

01:46

Then, all the water source heat pumps on your system appear, based on the graphic overrides assigned by the family system type.

01:55

Finally, select a water source heat pump in your piping system and switch to the Piping Systems contextual ribbon.

02:03

The System Selector then shows you all the systems that the selected water source heat pump belongs to,

02:10

and the Properties palette updates with all the system properties.

Was this information helpful?