Module

20 min.

Use Civil 3D to document the road design

Module overview

When you have the design right where you want it, you can document the design. Taking advantage of Sheet Set Manager can speed up the creation of the Plan and Profile sheets. In this module, you learn how to cut the plan and profile up into sheet-sized views, then make modifications as necessary.
 
This module takes approximately 20 minutes to complete. By the end of the module, you should be able to: 
  • Prepare the plan and profile model using data shortcuts
  • Create view frames for plan and profile sheets 
  • Create plan and profile sheets from view frames
  • Adjust profile splits in the sheets  
  • Cut section sheets

Module pre-requisites

This module requires user-level knowledge of Civil 3D and is focused on best practices and its industry applications. If you don't have experiences with this product, we recommend you to take foundational training using one of the resources below:

About the author

This module was created by Russ Nicloy, Civil Solutions Specialist.

Before you start

  • Please make sure you have the Civil 3D software loaded.
  • If you have technical difficulties, please reach out to product support. 

Module downloads

These downloadable resources will be used to complete units in this module:

Module outline