Module
25 min.
Run pre-made scripts using the Dynamo player
Module overview
Learn to run a pre-made script using the Dynamo Player inside Dynamo for Civil 3D. Learn where to find and store pre-made Dynamo Scripts. You'll also learn how to open the Dynamo Player and path to the appropriate folder location. Finally, you set the appropriate input and output values and then run the script.
This content takes approximately 25 minutes to complete. By the end, you should be able to:
- Locate and select existing Dynamo Scripts
- Define script input and output values
- Apply script to Civil 3D drawing
About the author
This content was created by Stacey Morykin.
Before you start
- Please make sure you have the Civil 3D software loaded.
- If you have technical difficulties, please reach out to product support.
Module downloads
These downloadable resources will be used to complete units in this module: