Add bar joists

By modifying the perimeter beams in the roof plan to sit lower to accommodate the joists, use the beam system command to place the joists.

After completing this video, you’ll be able to:

  • Load specific bar joists.
  • Set 3D snapping.
  • Add new beam systems.

Any referenced datasets can be downloaded from "Module downloads" in the module overview.

Video quiz

To maintain a 64 mm offset for the bar joists to be seated on top of a framing member, what steps must be taken to ensure the top of steel elevation is correct?

(Select one)
Select an answer

1/1 questions left unanswered