Learning

Certification

Certification overview

Architecture, Engineering & Construction

Design & Manufacturing

Media & Entertainment

Support & Policies

Learning

Module quiz

5 questions

With the WCS set on the top of a vise, the Bottom Height set at the same location and an Adaptive toolpath with .05 Radial stock to leave and .02 Axial stock to leave, what is the final Z height of the toolpath?

(Select one)

-0.05.
0.02.
0.05.
-0.02.

Select an answer

What is a potential issue with using 2D Contour toolpaths on complex geometry?

(Select one)

Collisions on lead-in and lead-out movements because the toolpath isn’t model aware.
Inability to repeat finishing passes on complex geometry.
Only able to make a single pass on a selected chain or edge.
Inability to define multiple roughing or semi-finishing passes.

Select an answer

Which toolpath geometry option allows a 3D Adaptive Clearing toolpath to calculate remaining stock to be machined and avoid “air cutting” where stock has already been removed?

(Select one)

Rest Machining.
Tool Orientation.
Machining Boundary.
Model.

Select an answer

What information can only be validated by machining a part?

(Select one)

Fixture design.
Collisions.
Complete stock removal.
Feeds and speeds.

Select an answer

Which selection is needed for a bore toolpath?

(Select one)

Axis to define a hole.
Cylindrical or conical face.
Center point of a hole.
Center point and bottom of a hole.

Select an answer

5/5 questions left unanswered