Move Through Project Drawings (5:24 min)

Project: Move Through Project Drawings

 
 

 

 

 

 

Completion Time:  5 minutes

 

Prerequisites

        Completion of the Moving Through Projects Lesson

 

Objective:  In this exercise, you use the Project Manager, Previous Drawing and Next Drawing, and the Surfer tool to move to and open drawings in the active project.

 

Instructions 

 

1:  If the Project Manager is not displayed, on the Project tab, Project Tools panel, click Manager.

 

 

2:  If Project_Basics_NFPA is the active project, skip to step 5. If it is open but not active in the Project Manager:

> Right-click Project_Basics_NFPA.
> Click Activate.
> Skip to step 5.

 

3:  In the Project Manager, click Open Project.

 

4:  Browse to where you installed the project exercise files. Select Project_Basics_NFPA.wdp. Click Open.

 

5:  In the Projects list, click the expansion node next to Project_Basics_NFPA to expand the drawing list.

 

6:  Right-click Project_Basics_NFPA_04.dwg. Click Open.

 

7:  On the Quick Access toolbar, click Next Drawing.

 

 

8:  On the Quick Access toolbar, click Previous Drawing.

 

 

9:  Zoom in to the relay coils CR407, CR408, & CR409 located in the middle of the first ladder.

 

10:  On the Quick Access toolbar, click Surfer.

 

 

11:  From the drawing, select the relay coil CR409.

 

 

12:  In the Surf dialog box, select the child contact listing, NO, 6,634. Click Go To.

 

 

13:  If requested, click OK to save the drawing with Qsave.

 

 

14:  In the Surf dialog box, double-click the parent coil listing, p 4,409.

 

15:  You can change the zoom factor used by the Surfer utility. Click Zoom Out.

 

16:  Click Close to exit the Surfer tool. The current drawing location and view are displayed.

Â