Module
25 min.
Conduct a massing study in Forma
Module overview
Get a hands-on technical lesson where you will learn how to create a project and populate base layers, draw a model and gain insight into key project metrics, analyze sun hours and daylight potential, and compare results of different designs.
This content takes approximately 25 minutes to complete. The objectives:
- Introduction to the workflow.
- Project creation and layer editing.
- Understand the basics of design tooling.
- Perform analysis and visual comparison.
Before you start
- Make sure you have access to a Forma Hub.
- If you have technical difficulties, please reach out to product support.
About the Authors
This content was created by Catharina Lundby and Robin Franke, Customer Success Managers (Forma) at Autodesk.