Final test

Now that you've completed the material, take the assessment to measure your skills on the topics learned.

Required for course completion

10 questions

Why would stock in a Fabrication Setup not have stock offset on the Top or Bottom?

(Select one)
Select an answer

Where can the total Machining time metric for all operations be found?

(Select one)
Select an answer

Which documentation visually helps a machine operator locate the coordinate system on a part to be cut?

(Select one)
Select an answer

If a laser cutting machine was being used to Etch the surface of a part, where would this setting be enabled?

(Select one)
Select an answer

What is the WCS for a CAM Fabrication setup?

(Select one)
Select an answer

Which toolpath setting allows for the last position of a cut to extend past the first position of a cut?

(Select one)
Select an answer

If a warning is visible on a toolpath stating that passes were discarded due to linking constraints, where should you make edits to a 2D Profile toolpath?

(Select one)
Select an answer

What are the three types of fabrication cutting tools?

(Select one)
Select an answer

How does the Kerf Width relate to the centerline of the 2D Profile toolpath?

(Select one)
Select an answer

What does the Tabs option do in a 2D Profile toolpath?

(Select one)
Select an answer

10/10 questions left unanswered

Was this information helpful?