Which of the following is included in a Setup Sheet?

(Select one)

Machine identification.
List of tools used in a setup.
Physical material of stock.
Fixture manufacturer.

Select an answer

Why is it important to select a holder during tool creation in a tool library?

(Select one)

To validate collision checking in simulation.
To have an on screen visualization of the holder.
To enable through tool coolant.
To properly set the spindle speed.

Select an answer

Why would a user create stock from a solid in a CAM setup?

(Select one)

To ensure the stock being used is rectangular.
To create a corner point to move the WCS location to.
To add stock to all sides of a part evenly during CAM definition.
To easily control the location of stock relative to the 3D part to be machined.

Select an answer

In an NC program, why is the Post selection important?

(Select one)

Selects a translator to convert toolpath information into machine readable code for a specific machine and controller.
Selects which toolpaths will be outputted as machine readable G-code.
It determines the program name, number, comment, and output folder location.
Sets the safe retracts and home positioning as well as the coolant for a machine.

Select an answer

What is the 2D Contour toolpath used for?

(Select one)

Remove large amounts of material.
Finish the floor and wall of a pocket.
Create a finish cut around a selected edge.
Bore a large hole in a part.

Select an answer

When simulating toolpaths in Fusion 360, which colorization option will change the color of the stack based on the underlying part model showing if material is left or if too much has been removed?

(Select one)

Material.
Tool.
Comparison.
Operation.

Select an answer

Which parameter controls the scallop height of a flow toolpath?

(Select one)

Cutting mode.
Number of stepovers.
Tolerance.
Direction.

Select an answer

What is the 2D Adaptive Clearing toolpath used for?

(Select one)

Finish the floor and wall of a pocket.
Create a finish cut around a selected edge.
Bore a large hole in a part.
Remove large amounts of material efficiently.

Select an answer

How does machine simulation differ from simulation?

(Select one)

Machine simulation shows the motion of the machine table and spindle.
Machine simulation validates the total machining time.
Machine simulation displays the total travel in X, Y, and Z.
Machine simulation shows the spindle move in X, Y, and Z.

Select an answer

What is the default facing toolpath cutting height?

(Select one)

Bottom of model.
Bottom of stock.
Top of model.
Top of stock.

Select an answer

Final test

Which of the following is included in a Setup Sheet?

Why is it important to select a holder during tool creation in a tool library?

Why would a user create stock from a solid in a CAM setup?

In an NC program, why is the Post selection important?

What is the 2D Contour toolpath used for?

When simulating toolpaths in Fusion 360, which colorization option will change the color of the stack based on the underlying part model showing if material is left or if too much has been removed?

Which parameter controls the scallop height of a flow toolpath?

What is the 2D Adaptive Clearing toolpath used for?

How does machine simulation differ from simulation?

What is the default facing toolpath cutting height?